![]() ![]() Once the automaton is programmed and configured, you are able to use it right away. Connect to Wi-Fi for activation: here, you can enter the SSID and password of the Wi-Fi needed for activation, skipping manually entering in the information during the workflow itself.If the Erase Mac option is checked, the Automaton will select the “Erase Mac…” menu option to erase the Mac prior to installing macOS and resources. Boot into recovery: in Apple Silicon, the Automaton can boot into recovery for you to run the workflow.A volume with the same name will be created so that Imagr can then proceed normally. To avoid being prompted for a password when running the workflow, this option will instead have the Automaton open Disk Utility and delete the first volume in the recovery partition prior to running Imagr. Open Disk Utility and erase first volume: This is for use with volumes that have FileVault enabled.macOS that came with your Mac, or the closest version still available (⇧⌥⌘R).Latest macOS that is compatible with your Mac (⌥⌘R).Latest macOS that was installed on your Mac (⌘R).This option can also be configured to boot to the different recovery partition options available ( Note: some of these may not be available for older macOS versions): ![]() Instead the Automaton will wait to receive commands later using its command line interface. Unchecking this option will disable the Automaton’s normal function of immediately issuing keyboard commands to boot to the recovery partition. Boot into recovery: Usually this should be left checked.This setting will enter the required firmware password before booting to the recovery partition. Firmware Password: Use only if the target Mac has been configured to use a firmware password.Delay before running command in Terminal: Additional time before the command is executed.Delay before opening Terminal: The amount of seconds between pressing ⌘R and issuing the commands to open Terminal to run the command.SMB Server mkdir /tmp/mnt & mount_smbfs /tmp/mnt & hdiutil mount /tmp/mnt/mds/MDSDiskImage.dmg & /Volumes/MacDeployStickResources/run Web Server hdiutil mount & /Volumes/MacDeployStickResources/run Depending on where the resources are located, the command will be different. It should be adjusted to match the name of the external volume (replace “mds” with the name of the volume that contains the MDS resources). Command: Listed is the command that will run in Terminal in the recovery partition.MDS will prompt to update the Automaton if it has older firmware than what is provided in the current MDS version. Version: View the current Automaton firmware version.These values can be adjusted using the Configure Mac Automaton sheet. It will then wait for a defined startup delay before issuing the commands for opening Terminal and running the specified command. The Automaton will press ⌘R a few seconds after it has been plugged in. SettingsĬlick “Configure Mac Automaton” to change options. Note: the MDS Automaton must be connected when the configuration sheet is shown as it only listens for a connection over a few seconds on initial power. ![]() Once the Configure sheet is displayed, plug in the Automaton using the provided USB cable. To configure the MDS Automaton, launch MDS and click the “Configure Mac Automaton” button. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |